resetToDef -p all NOTE: This option will reset all settings, including network configuration settings. Resetting to Defaults via Command Line (console): 1) Log into the console via Telnet, SSH, or via a serial connection using Administrator credentials. If Exclude TCP/IP was selected, the web interface should be available again within a few minutes. NOTE: The NMC will take a few minutes to reset to defaults. Otherwise you will need to assign network settings again, unless using DHCP. NOTE: If you wish for the Network Settings to remain, you must check the box for Exclude TCP/IP. Resetting to Defaults via Web Interface: 1) Log into the web interface of the NetBotz 250 using Administrator credentials. Instructions on serially connecting: NetBotz 250 | Serial Connection (Driver + Serial Parameters)ģ) On the confirmation prompt type YES and hit. Rebooting via Command Line (console): 1) Log into the console via Telnet, SSH, or via a serial connection using Administrator credentials. Once rebooted the web interface should be accessible again. NOTE: The NMC usually reboots within a few minutes. Rebooting via Web Interface: 1) Log into the web interface of the NetBotz 250 using Administrator credentials.Ģ) Navigate to Control > Network > Reset/Reboot.ģ) Select Reboot Management Interface and click Apply.Ĥ) On the Confirm Action screen, click Apply. Process for resetting the configuration back to factory defaults on a NetBotz 250.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |